1. The large simulated dinosaur still has no operational response after being powered on normally.
Solution: First, we should check whether the indicator light of the corresponding function of the power supply is always on green. If there is no steady green light, check whether the power supply circuit is providing stable power supply. Or the green light is always on, check the corresponding sensor or receiver. Operate by using remote control or instructions to see whether the large simulated dinosaur can operate normally. If it cannot operate, repair and replace the sensor or receiver to solve the problem.
2. The skin of the large simulated dinosaur was maliciously damaged, scratched and damaged.
Solution: Since most of the large simulated dinosaurs are used for display after they are produced, various collisions and frictions will inevitably occur during the interaction with people. After long-term use, the outer skin of the large simulated dinosaur may be damaged and discolored. At this time, we need to repair the damaged and discolored areas. Since the exterior skin of large-scale simulated dinosaurs is mostly made of fiber and special glue, we can sew the damaged areas together during repairs. When suturing, we must pay attention to the alignment of the skin color at the damaged areas, so that we can We stitched them together so that the appearance of the dinosaur would not be messy. Then apply transparent glass glue evenly, and after drying, apply color again, and finally restore the appearance of the large simulated dinosaur to its original appearance.
